Detection Systems DS7080iP-32 Betriebsanweisung PDF herunterladen (Seite 46)

• Program Address 008, digit 2, must be programmed for the

Commercial mode (digit 2 = 0).

4. Zone Programming:

• The Burglar alarm output signal (whether pulsed or steady) must

be different from the Fire alarm signal.

5. Alarm Output Programming:

• Alarm Output, Program Address 009, digit 1 must be programmed

as *0 (A).

10.4 Using the Ademco AB-12 Bell/Housing

1) Disconnect the wire jumper from Terminal 4 to the inner housing of the Bell Box.

2) Connect wiring between the control and Bell Box as shown above.

3) Program Zone 8 as a 24-hour zone. (Program Address 030, digit 8, must be programmed as 2).

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 59 60

Keine Kommentare

Detection Systems DS7080iP-32 Betriebsanweisung Seite 46